AEROLAB'S SMOKE GENERATOR

The AEROLAB Smoke Generator produces dense white smoke by vaporizing white mineral oil as it flows through an electronically heated small-diameter stainless steel tube.

The (black) base unit consists of an air pressure regulator, a mineral oil reservoir, a heating element controller and an indicator light. After connecting the base unit to your compressed air system, the compressed air passes through the internal regulator. This regulated air then forces the mineral oil out of the reservoir. The air pressure regulator controls the oil flow rate. The mineral oil then flows through silicone and stainless steel tubing to the wand tip. In the tip, the oil is vaporized as it passes by a heating element. Desired smoke volume and density are achieved by simultaneous adjustment of oil flow rate and heating element temperature.

Inside an Aerolab Educational Wind tunnel.	Test Section Size 12 by 12 inch. Speed 140 mph.

SPECIFICATIONS

Base Unit
Dimensions	14.5 x 5 x 7.75 inches (36.8 x 12.7 x 19.7 cm)
Weight	10.5 pounds (4.76 kg)
Reservoir capacity	16 fluid ounces (473 mL)
Run time at highest flow rate	approx. 45 minutes
Short Smoke Probe
Overall length	18 inches (45.7 cm)
Insertion length	13 inches (33 cm)
Probe diameter	.625 inches (15.9 mm)
Weight	1 pound (0.45 kg)
Long Smoke Probe
Overall length	45 inches (114.3 cm)
Insertion length	40 inches (101.6 cm)
Probe diameter	.625 inches (15.9 mm)
Weight	1.7 pound (0.77 kg)
Custom Lengths Upon Request

Complete Unit Includes
1 Base Unit
1 18 or 45 Inch Smoke Probe (custom lengths extra)
1 Gallon Smoke Fluid (Kaydol white mineral oil)
1 Quick-Release Air Chuck (to modify existing air supply lines if necessary)
Instructions and Material Data Safety Sheets

System Requirements
110VAC, 50/60 Hz 375 Watts
Compressed air supply - 35 psi (241 KPa) min., 125 psi (861 KPa) max.
Type B power/extension cord or suitable adapter